电采暖炉调试的要点
    2014-6-6 11:59:48  文章来源:http://www.jnlzsb.com
    每年采暖期使用前,应检查温控器及电路系统是否正常、门窗的密封是否良好。调试时应控制室温平稳上升,直至达到设计要求;调试时间为一周,应保证第一天运行3小时,以后每天递增,直至达到全负荷运行。
    The annual heating period before use, should check the thermostat and circuit system is normal, the doors and windows of the seal is good. Debugging should be the control room temperature rise steadily, until it reaches the design requirement; debugging time for one week, shall ensure that the first day of 3 hours of operation, after the daily increments, until the full load operation.
    建议每年开始使用阶段(一个月)温度设在15℃-18℃,然后可根据需要设定温度。在电缆运行后您新添家具摆设,应考虑避免发热电缆运行时局部温度过高。环保采暖锅炉http://www.jnlzsb.com/
    The proposed annual began using the stage (one month) temperature at 15 ℃ -18 ℃, then according to need to set the temperature. In the cable running after your new furniture, should be taken to avoid heating cable runs the local temperature is too high.
    对温度的判断应该以自己的实感温度为准,相信自己的感觉,寻找最适合自己的温度。发热电缆供暖系统运行调试,必须由专业安装人员负责在混凝土层自然干燥后(约21天),具备正常供暖(最好是在采暖季前后)和供电的条件下进行。
    Should be subject to their real sense temperature on the temperature of judgment, I believe their feelings, to find the most suitable temperature. Heating system debugging, must by the professional installation personnel in charge of the concrete layer after natural drying (about 21 days), with normal heating (preferably in the heating season before and after) and power supply conditions.
<友情连结> 新利18luck jxf吉祥坊 云顶斗地主