环保采暖锅炉讲解锅炉运行前的八个准备事项
    2013-11-30 15:25:00  文章来源:http://www.jnlzsb.com

    1、检查锅炉所有人孔和手孔盖是否装好,各法兰密封处螺丝是否拧紧等,同时应检查法兰处装置的临时隔板及其它临时堵头是否全部拆除。

    1, check all the manhole and hand Kong Gai is installed, each flange sealscrew is tightened, and temporary baffle check flange device and othertemporary plug is removed.

    2、炉膛及烟道内的积灰及杂物应清除干净。风道及烟道的调节门,闸板须完整严密,开关灵活,启闭指示准确。

    Dust and debris, and the 2 furnace flue should be cleaned. Air and fluedamper, the gate must be complete, flexible switch, on-off indication accuracy.

    3、锅炉外部炉墙应完好严密,炉门,灰门、看火门和检查门等装置完整齐全,关闭严密。

    3, boiler furnace wall should be intact tight outside the door, door, ash, watch door and check the door device such as a complete, closed tight.

    4、检查安全附件是否完好;旋塞是否旋转灵活、好用;各种仪表和控制装置应齐全,究好、清洁。检查合格后,应使压力表旋塞处于工作状态。

    4, check the safety accessories are in good condition; whether the rotating flexible plug, good; a variety of instrumentation and control equipment should be complete, the good, clean. After passing the examination, should make thepressure gauge cock in working state.

    5、锅炉各种管道上的阀门手轮应完好无缺,开关灵活、密封盘根充足。检查合格后,开启锅炉进出水管道上的阀。门。

    The valve hand wheel 5, boiler pipe should be flawless and perfect, flexible switch, sealing packing enough. After passing the examination, open the water inlet and outlet pipe on the valve. The door.

    6、检查燃烧装置是否完好;对机械传动系统,输煤系统,出碴系统试转正常;调速箱安全弹簧压紧程度应适当,润滑良好;煤闸板尺指示正确.老鹰铁整齐、完好,翻碴板完整,动作灵活。

    6, check the combustion device is intact; handling of the mechanical transmission system, system, mucking system test switch to normal; controlbox spring pressing degree of safety should be appropriate, good lubrication;coal gate length indicating correct. Eagle Iron tidy, intact, turn the ballastboard complete, flexible action.

    7、检查辅助设备(引风机、鼓风机、水泵等)联轴器是否连接牢固;三角皮带松紧适当;润滑油应良好、充足;冷却水畅通。检查合格后,装好安全防护罩,分别进行试运转,并注意空转时的电流。除尘装置落灰口,应封闭严密,不可漏风。

    Auxiliary equipment (7, check the fan, air blower, water pump) coupling isconnected firmly; triangle belt tightness appropriate; lubricating oil should begood, adequate cooling water flow. After passing the examination, fix up a safety protective cover, respectively, commissioning, and pay attention tocurrent idling. Dust remover ash falling mouth, should be closed tight, noleakage.

    8、经检查锅炉符合运行要求后,即可开始进行.进水时应开启锅筒上的空气阀。进水宜缓慢,进水期间应检查人孔、手孔及各部位的阀门,法兰是否有漏水现象;否则,应停止上水进行处理。

    8, through the inspection of boiler and meet the operational requirements, you can start. The water should open the air valve cylinder. The water should be slow, should check the manhole, hand hole and the various parts of the valveinlet, flange for Water Leakage phenomenon; otherwise, should stop watertreatment.

    环保采暖锅炉http://www.jnlzsb.com/ 

<友情连结> 新利18luck jxf吉祥坊 云顶斗地主